2020. 2. 27. 10:56ㆍ카테고리 없음
AuthorMessagemmadelaDD-WRT NoviceJoined: 08 Jun 2011Posts: 2Posted: Wed Jun 08, 2011 17:27 Post subject: D-Link DIR-600 rev B5There is another revision of the DIR-600 router available on the marketFCC-ID: KA2IR600B5it is built on Ralink RT5350,contains 32MB RAMno info about flash sizeAn attempt to initial flashing described inwithdlink-dir600b-factory-webflash.binfails with message'Invalid image file. Please select the correct image file and upload it again.' Router came with FW 2.10 dated 26 Jan 2011,this FW is not available in internetSponsor.
D Link Dir 600l As Repeater
The factory default IP for this router is 192.168.0.1, user is 'admin', password is blank. Pros of this hardware. 4 MB board, so no need to use 'micro' DD-WRT builds. Fairly inexpensive.
Fairly new hardware (released in 2009?), so it's widely available for purchase new. Reasonably fast CPU clock speed. Easy to install DD-WRT on this hardware (just flash through the web interface as per below, and you're done). According to Ralink's website, the chip has a ROM built-in and this means there is no boot code to crash or mistakenly erase. The ROM contains a bootloader and emergency room web page to recover flash firmware. Translation: You're unlikey to brick it. Cons of this hardware.
This Ralink hardware does not support wireless mode ( ). It does however support mode, which is similar, but a bit more complicated to set up. No USB port, so cannot be a NAS for a USB drive, nor can it be used for of a USB printer.
As it is Ralink chipset based, support by DD-WRT is still limited in terms of firmware builds availability and community support compared to Broadcom based routers. Currently the only build from BrainSlayer doesn't include JFFS/CIFS client support. The LAN Port based VLAN is not supported. You can not assign the LAN Ports with VLAN. However, there may be a.DIR-600 C1 and C2 not compatible to DD-WRT!!Router detailsAdditional informationChipsetRT3052F. DD-WRT Wiki.
D-link Dir 600 Firmware
TomatoVPN on DIR-600Tomato is a small, lean and simple replacement firmware for, and other Broadcom-based routers. So i see here: that D-Link Dir 600 is for VNP and i have one and i installed dd-wrt on it and it has no open vnp option on server- vnp ust pptpany help?You and I are out of luck (as many others, perhaps). I have the very same router ( Version B1 / B2 Chipset RT3052F) and the same problem, NO OPENVPN, just PPTP SERVER and PPTP CLIENT.Last night, I tried to flash this firmware: WHR-G300N-openvpn-webflash.bin to no avail.OpenVPN-yes, Wireless - yes and all menus appeared as expected (OpenVPN included) but ETHERNET PORTS completely dead. I had no problem to make it work back with former firmware.Wanna give it a try to WHR-G300N-openvpn-webflash.bin?This thread gave me the idea:-Worked but it has a problen seting up a the OpenVNP doesnt have the commands so its useless.